System Manager Software, version 3.3.2.3 Service Update is a free update to registered users of SMS version 3.3 or higher. SMS 3.3 or higher must be installed on the PC to which you are installing this upgrade. 

• PM700:  Configuration, real-time readings, and PC-based logging.
• PM800 I/O: This new feature provides I/O configuration for these modules: PM8M2222, PM8M26, PM8M22.
• MCM (Multi-Circuit Monitor): This device can now be used to generate electrical cost summary reports.
• Disturbance Detection Direction: (available in CM3000 and CM4000 monitors with disturbance alarms) The circuit monitor can be configured to report the location of the cause of a disturbance. The location is reported as upstream or downstream from the meter location. This information is listed in the State column of the Active Alarms log and in the on-board alarms log.
• New SMS Standard Tables: These new tables have been added:
  • Power Quality Index Readings: Summary of PQ values with weekly, monthly, and yearly trends for a single meter
  • Power Quality Summary: Summary of overall PQ for multiple meters
  • Alarm Summary Readings: Summary of alarms for a single meter
  • Alarm Trend Readings: Monthly and yearly trending for common alarms for a single meter
  • Digital Output Readings: Status, count, and on time for digital outputs
  • Digital Input Readings: Status, count, and on time for digital inputs
  • Input Metering Usage Readings: Usage and trend information for input metering channels
  • 1-4 Interval Energy Readings: Interval energy for various intervals for a single meter

1. Click the link below and Save the SMS 3323 ENG.exe file to your PC's hard drive. File Size 105 MB. 
2. After downloading, double click on SMS 3323 ENG.exe to extract and run the install 
3. Follow the instructions in the 63220-060-208-C1.pdf document to install the upgrade. 
   
   IMPORTANT: If you are upgrading from SMS 3.3 you must run setup.exe for both disk images contained in the SMS 3323 ENG.exe upgrade. If you are upgrading from SMS 3.3.2 or later, you only need to run the setup.exe from Disk 2.